How to install the carbon fiber spoiler with in 10 mins?

Note: It is recommended to cooperate with more than two people.

Tool preparation: hand-held drill, rag, 3M glue, adhesion promoter, textured paper, screwdriver, screw

The first step: try on. Remove the front lip spoiler and place it in a suitable mounting position. Mark the location on the car where the product will be affixed with textured paper.

The second step: cleaning. Clean the auto front bumper with 3M glue with alcohol, gasoline or acetone.

The third step: apply the adhesion promoter. After the cleaning agent is dry, apply the adhesion promoter evenly to the position where the 3M glue needs to be applied.

The fourth step: paste. Remove the 3M glue from the front lip splitter, tear the ends of the 3M adhesive tape to about 10cm, and then stick the carbon fiber front lip along the pre-positioning point on the car. At this time, slowly tear the 3M glue and press it tightly until the adhesive tape is torn off. .

The fifth step: fixed. Secure the car front lip to the front bumper cover with a self-tapping screw at the bottom of the front bumper.

After the installation is completed, it can be heated with a hot air blower to improve the 3M adhesiveness and make the paste more perfect!