Be sure you are not familiar with carbon fiber car body kits process without enough knowledge

JCSPORTLINE as China's largest carbon fiber auto parts manufacturers ,we can tell you what you need to do.

1. The workers must be equiped with 3M masks and knitted gloves when trimming,if necessary,protective eyewear is required.

2. The air injection die should be smooth,flat and without obvious defects.

3. After the air mould is finished, the ash is adjusted to repair ti,so that it is smooth and  smooth.

Fourthly,after the primer repair is completed,sand paper sand will be leveled out for the water model room.Every place should be sanded.

Fifth,after the water model has been dried,the primer is sprayed and baked in the paint room.

Before polishing the product, check the tool and put on the mask before starting operation

Do not lift the polishing machine, the center of gravity on the product, along with the polishing machine strength.

The polishing machine speed should be adjusted to slow down when the edge throwing product Angle

Do not mention the polishing machine too fast, to avoid the appearance of marks.